Matlab App.Uifigure:11 A new post. Let’s create an Arduino library Create a directory for your image library with the ~/src/ directory. Go to your Arduino or any Arduino IDE install and copy coder. Create an app Navigate to Arduino/com_art/library and open it. When you’re ready, run “solaric-sdk” After a short wait, you should see an instance of Coder.CreateImage.cpp. Copy. This just added an instance of Arduino.CreateData to its example folder in image.cpp. Go to the Coder library directory and open it. Once you found it, you will see a “Serial.Number” parameter field in your code. If there’s no serial number in your code, then copy it to the place you used previously as shown in the coder. Make sure you create an instance of Coder.Copy with “solaric-sdk” and add the Serial.Number parameter in your serial_number field to the constructor and save the “Serial.Number” code in the “init.h” file. Create a class project Go to your Arduino app developer page and make sure you added the following code: 1 # start the project add a few lines def initialize ( x, y ) : System. env. Zx. start_vdi ( 25, 25 + 25 ) end end